Pre-Ignition X2 Assembled- Fully Speeduino Compatible
Fully Compatible with the the official Speeduino Firmware! No code modification required!
Included:
Pre-Ignition x2 Standalone ECU (Assembled minus main Connector)
2x12 Connector (Enough Female Pins to make a few mistakes while crimping)
Items you may need:
Experience the best of both worlds – the freedom of open source with the convenience of ready-to-use hardware. Our stand-alone ECUs embody the spirit of innovation with 100% open source technology, featuring the renowned Speeduino open source firmware. Not only is the firmware customizable, but DetonationEMS hardware itself is open source. Rest assured, our ECUs are designed to offer peak performance right out of the box, ensuring a seamless experience for users who prefer a hassle-free solution.
Affordable: Compared to other high-performance ECU kits on the market our products are an affordable option that does not compromise on quality or reliability.
Supportive community: With well-documented instructions and a large community of users, you'll have plenty of resources to turn to if you need help or advice.
Fully tested before shipping: Each unit is thoroughly tested before shipping, ensuring that it meets our high standards for quality and reliability.
Hardware feature List:
Supports up-to 4 cylinders of Fuel and Ignition control using batch injector mode and wasted spark.
2 Injector output channels
2 Ignition outputs channels with selectable logic level (12V/5V)
4 Fully protected pre-configured input channels for CLT, IAT, TPS, and O2 sensors
2 Customizable spare analog inputs for oil pressure, fuel pressure, and more
2 Trigger inputs for Crankshaft and Camshaft position sensors
1 Spare digital input (most often used for vehicle speed)
1 Duel VR conditioner mount (VR Condition not included)
1 SMD Map sensor mount location (Pre-Installed sensor optional)
1 DRV8825 stepper module mount location for Stepper Idle Control Valves
4 Customizable high-current (1A max ground switching) spare outputs for Idle Control Valve, Boost Control, VVT, and more
1 Pre-configured output for tachometer
2 Pre-configured outputs for Fan and Fuel pump control via ground switching relay
1 Flex Fuel Sensor Input
1 Clutch Switch input (ground switching only)
1 Serial3 header often used with HC-05/HC-06 Bluetooth Module (See Speeduino Wiki for setup instructions)